
inode
- Registriert
- 28.12.02
- Beiträge
- 2.755
- Reaktionen
- 0
- Punkte
- 2.990
hi forum,
ich habe ein rane mic1 "back-electret condenser" mikro erworben. nun muss ich mir eine spannungsversorgung basteln, da ich nicht den passenden analyzer habe. ist nicht sehr aufwändig, ich bin mir einfach nicht ganz sicher beim schaltplan
das mikro hat einen mono klinken stecker.
"tip" ist die spitze und "ring" der hintere kontakt ?
zusätzlich steht noch:
"Plugging the TS plug of the RA 27 mic
into the [g=408]TRS[/g] input jack causes the ring to be shorted to the
sleeve which completes the battery circuit to ground."
heisst das, dass ich auf der "input from mic" seite sleeve und ring verbinden muss?
anleitung ist von hier
gruss
inode
ich habe ein rane mic1 "back-electret condenser" mikro erworben. nun muss ich mir eine spannungsversorgung basteln, da ich nicht den passenden analyzer habe. ist nicht sehr aufwändig, ich bin mir einfach nicht ganz sicher beim schaltplan

das mikro hat einen mono klinken stecker.
"tip" ist die spitze und "ring" der hintere kontakt ?
zusätzlich steht noch:
"Plugging the TS plug of the RA 27 mic
into the [g=408]TRS[/g] input jack causes the ring to be shorted to the
sleeve which completes the battery circuit to ground."
heisst das, dass ich auf der "input from mic" seite sleeve und ring verbinden muss?
anleitung ist von hier
gruss
inode